info@tsmoly.com | 800.508.5545

GD-525 Moly Grease
[GD-525-004]

4 oz jar

Applications

GD-525 Moly Grease is a synthetic, high temperature grease designed for all types of splines.  For motorcycles with shafts, use it to lubricate u-joints, swing arms, bushings, pins, etc.  (GD-525 is not a lubricant for wheel bearings and chains.)  GD-525 is compatible with seals & o-rings.  For industry, GD-525 is a general purpose EP machinery grease, including a "fifth wheel" and king pin grease for trucks.

Benefits

GD-525 Moly Grease provides uniform and durable boundary lubrication under extreme pressure to prevent wear on the two mating steel surfaces over a wide temperature range. With a high dropping point, it will not run off from heat. GD-525 is adhesive to prevent wash out and sling off. Moly is a solid film lubricant with a low coefficient of friction and an affinity for steel and other metals.  The moly decreases friction of the two counter-moving sliding surfaces by filling in microscopic pores of the metal surfaces and plating out over the surface.   The fluid component of GD-525 is a blend of synthetic hydrocarbon base stocks, commonly called "synthetic oil" (Groups IV & V).  Hydro processed mineral oil or a mineral/synthetic oil blend is not used.  The synthetic oil in the grease has a higher tolerance for heat than mineral oil, which means GD-525 resists oxidation and evaporation; the synthetic oil creates a stronger film of lubricant than mineral oil.  In combination, the components of GD-525 provide exceptional capability to reduce friction and wear over a long period of time.

Molybdenum disulfide: Moly is a solid film lubricant with a low coefficient of friction and an affinity for steel. The moly decreases the friction of the two counter-moving sliding surfaces by filling microscopic pores of the metal surfaces and plating out over the surface. GD-525 lessens metal-to metal contact to reduce friction and wear.

Typical Observations

NLGI* gradeNo.  3
GelInorganic
FluidSynthetic
Viscosity Index D 2270139
Pour point, 0C ASTM** D 97 -180C (00F)
Flash point, Cleveland Open Cup, ASTM D922380C (4600F)
Fretting wear, mg, ASTM D 41706.50
Water spray off, %, ASTM D 40494.98**
Molybdenum Disulfide, %30.00

*-National Lubricating Grease Institue

**-American Society for Testing Materials

***-Competitive products: A) 53.20%  B)85.86%  C)98.19%  D)56.33%

How to use

For splines, clean off old lubricant with a solvent.  Let dry.  Burnish ("rub") GD-525 on and in the metal surfaces with a clean, lint-free cloth.  Leave a thin coating of grease on surface.  Work it into the crevices of u-joints and other mechanical components.  Also, leave a thin coating of grease on the surfaces.   

For SDS, please eMail or call:

Tel: (713) 671-2676

Toll Free: (800) 508-5545

info@tsmoly.com

$31.95

SKU : GD-525-004
Categories : Grease